With the development of society, vegetable cutters have gradually entered our lives, but we are still not clear about this large-scale kitchen equipment, so how to run the vegetable cutters well, about accidents caused by improper use of vegetable cutters There are many, below, we will introduce the safety instructions of the vegetable cutting machine to you, hoping to help your family.
1. Trial cutting before work to observe whether the specifications of the vegetables to be cut are consistent with the required specifications. Otherwise, the thickness of the slices or the length of the vegetables should be adjusted, and normal work should be carried out after meeting the requirements.
2. Install the vertical knife ①Install the vertical knife on the intelligent vegetable cutter: put the vertical knife on the fixed knife plate, the cutting edge is in parallel contact with the lower end of the fixed knife plate, the fixed knife plate is pinned on the knife rest, tighten the knife nut, remove the Just set the blade. ②Installation of vertical knives on other vegetable cutters: first turn the adjustable eccentric wheel to make the knife rest reach the bottom dead center, and then lift the knife rest up by 1/2 mm, so that the vertical knife is in contact with the conveyor belt, and then tighten the nut Fasten the vertical knife to the knife holder. Description: The height of the elevated rack can be mastered according to the vegetables to be cut. If the lifting height of the overhead rack is small, the vegetables may even be cut. If the lifting height of the overhead rack is too large, the conveyor belt may be cut.
3. Adjustment of cutting length: Observe whether the length value displayed on the control panel matches the required length, press the increase button when increasing the length, and press the decrease button when decreasing the length. Other vegetable cutting machine adjustments: turn the adjustable eccentric wheel, loosen the connecting rod fastening screws, and the fulcrum can be moved when cutting thin wires, from outside to inside; when cutting thick wires, the fulcrum can be moved from the inside to the outside. screw








