In recent years, our factory has continuously launched new products, products have been serialized, product quality has been steadily improved, and standardized development has won the unanimous approval of our customers. Sometimes there are some faults in the straw briquetting machine, so how do these need to be eliminated?
1. Motor start
The material cannot be started after molding, because of the material agglomeration during the downtime, the dead stuck or the shutdown did not die in the water caused by drying and dead mold material. They are excluded from the flattening of the mold material, cleaning, the moisture content of the material, and then turning on the motor and re-release.
2. Unformed starter feed
Improper guiding of forage moisture or thermal deformation of the temperature in the mold is due to the failure to meet the working requirements. The moisture content of the raw material should be between 15 and 22, and the clumping rate is more than 98. The exclusion is the required water content to be added to the forage moisture, and it can prolong the temperature in the material processing mold at the beginning. In order to Better shape forage.
3. Vibrate with sudden rhythm or send regular sounds
When this happens, because there is hard-to-change debris falling into the hole there is a loose mechanical part, the production process, and then through the mechanical rotating parts loosening when the turn is caused by the remedial measures, immediately stop the inspection and clear the sundries in the die hole and check Mechanical parts tighten loose parts and restart.
4. Productivity drops
Productivity drops, the gap between the die gap between the rolls and the pressure is large, as long as the roll and the pressure are adjusted to the gap between the die, it can solve the cause.
5. The sound of the motor is dull
This happens because the material is too loose and there are too many material cavities, causing blockages. Change the method, first, adjust the moisture of the material, second, clean the material in the ring die, and third, according to the ammeter Feeding speed, the speed is fast, the more feeding, the slower the feeding, the less feeding.
6. The speed is unstable
The reason is that the failure to add the material is uneven, it should be fed according to the speed of the rice, the faster the speed, the more feeding, the slower the less feeding, and the continuous feeding as evenly as possible, so that the material can form a briquette better.
7. Roller slips
Roller Cylindrical roller slip and wear is serious, because the flower pot or has been ground, the roller should be repaired or replaced.
8. The motor does not start
The material is jammed, the motor is overloaded or there is a leak. The remedial measures are: motor overload protection device, and then start to clear the blocking material; leakage protection and other devices, check whether there is leakage, and then turn on the motor.
