goldenmachinerysusan@gmail.com    +86-15838007835
Cont

Have any Questions?

+86-15838007835

Jun 03, 2022

What Are The Precautions For Debugging And Internal Maintenance Of Briquette Mechanical Briquetting Machine

Precautions for debugging and internal maintenance of the briquette machine , then how should debugging and internal maintenance? Let's take the briquette briquette machine as an example.


Debugging of briquette mechanical briquetting machine


1. The no-load test run of the briquette briquette machine production line is carried out by the following equipment one by one to check whether the running direction of the motor is correct, whether the main machines in the production line of the briquette briquette machine are running normally, and whether the bearing temperature rise is too high. high, whether the amount of lubricating grease is added, if it is abnormal, stop the vehicle to check the fault, and then start the test drive again.


2. The whole line of briquette mechanical briquetting machine production line is put into operation. The sequence is to start the equipment one by one. After the whole line of laterite-nickel ore briquetting machine runs normally, it is put into operation. Add a small amount of materials at first, and gradually return to normal. Check whether each machine in the briquette machinery production line is boring, whether the current is too large, and whether the chute discharges smoothly. Drive again.


3. The whole line of the briquette mechanical briquetting machine production line should run continuously for 4-8 hours. If there is any abnormal situation, stop the machine one by one from the front to the back, and restart the operation after troubleshooting. calculate.


Internal repair and maintenance of briquette briquetting machine


1. If there is oil leakage in the hydraulic system during operation of the briquette briquetting machine, don't panic at this time, you should stop it quickly, wait for the oil leakage to be repaired, and then restart.


2. In order to prevent dust from falling into the inside of the briquette briquetting machine, the external dust should be cleaned in time to prevent the internal parts of the briquette briquetting machine from being worn, and attention should also be paid to the dust during the disassembly process and deal with it in time. Avoid falling into other moving parts.


3. If the internal parts of the briquette briquetting machine are found to be worn, replace the bearing grease immediately, clean it up, and observe the oil pressure of the oil cylinder. If it is found that the oil pressure has a large pressure change, new oil should be injected immediately. , Open the inspection cover of the reducer, the tooth engagement and wear status of the keyway gears, check whether the foundation and safety bolts are loose, and tighten them.


Send Inquiry